Similar Posts
DHC2
Repairing a Beaver horizontal stabilizer, opening up a can o worms
Tail problems
After removing the tail we found that an earlier replacement of the tail bulkheads with a later model 180 bulkhead, probably because of the plane going over on its back, was not done very well…….
Helicopter
Floor viewing window for swing loadsThis was a fun job, but like most metal working jobs it always takes longer than they say. It also takes a bit of thinking as you do the installation about how it fits, it maybe different than the drawing, or holes may not be able to go where they…
Cowl louver
There is an STC for these but it has long since become a floating STC. I installed these as a minor alteration but used the STC as my data for installation. It is a pretty simple sheet metal project but you have to be careful. I do have these louvers coming available soon as a…
Cessna 180 baggage door and more
Removing a camera hatch in my 1953 Cessna 180 and installing a baggage door.Specializing in minor and major sheet metal repairs to Cessna 180 and Cessna 185 aircraft. Repairing control surfaces to major gearbox repairs as well as STC modifications or service bulletins. This shows a little of the removal of a camera hatch in my Cessna…