Cessna 170B wing repair

We used a English Wheel to make this cowl for this Taylorcraft that was once owned by Ramblin’ Rod. Ramblin’ Rod had a children’s show in the 1960’s which kids would go to, sit on the bleachers and watch which I was one of. Using an English wheel is a lot of fun but takes…

B19 same as B23Sheet metal work is as much an art as a skill. Most of the time there is very little to guide you other than a picture, some references in the maintenance manual or parts manual. And of corse the AC 43.13 to reference to. What also counts I’d how the repair or…

 After removing the tail we found that an earlier replacement of the tail bulkheads with a later model 180 bulkhead, probably because of the plane going over on its back, was not done very well…….

One of the hardest parts about this job was removing the wings. I do not think they had ever been off and it took some heat, a 5x rivet gun, big hammer and a long brass rod but we finally did it. The owner found a used spar that passed an eddy current test, took…

Replaced both left and right horizontal tips with Mc Farlane tips using 8 32 screws in place of rivets. The idea is that you can easily change out the tip if damaged, one thing is that if you operate a seaplane you need to put some corrosion protection on the nut plates and screws on…