
Similar Posts

Wing rebuild
Currently working on a ground loop repair to a Cessna 170B wing. If you watch you will see the three measurements for twist, the tool is made such that it should always be zero, the inboard, the middle, and the tip. You can see the twist is out by .7 which means it has only…

Fuselage repair
It all starts with rivets and time.

Taylorcraft cowl
We used a English Wheel to make this cowl for this Taylorcraft that was once owned by Ramblin’ Rod. Ramblin’ Rod had a children’s show in the 1960’s which kids would go to, sit on the bleachers and watch which I was one of. Using an English wheel is a lot of fun but takes…

AD 2020-18-01 this is an inspection of the lower door post for cracks on 182
This is a 12000 hour Cessna 182, the cracks are found in the corner of the web, hard to see. Once the crack was found the aircraft was grounded, no ferry permit allowed. We spent three long days and travel to get the job done

Tail problems
After removing the tail we found that an earlier replacement of the tail bulkheads with a later model 180 bulkhead, probably because of the plane going over on its back, was not done very well…….

Cessna 180 baggage door and more
Removing a camera hatch in my 1953 Cessna 180 and installing a baggage door.Specializing in minor and major sheet metal repairs to Cessna 180 and Cessna 185 aircraft. Repairing control surfaces to major gearbox repairs as well as STC modifications or service bulletins. This shows a little of the removal of a camera hatch in my Cessna…