Tail fix
Slowly climbing out of the rabbit hole. Had to replace the Vertical rear spar and both bulkheads and make sure all was right when reassembled to make sure we did not repeat the mistake that was done the last time the tail was apart.
Similar Posts
61A getting close
After months of rehab 61A is getting near the end. As usual the last 10% is 90% of the job but it is all coming together. Overhauled gear from Landing gear works…..not cheap but not bent…
Working on the projects
Our 180H, N52010 is coming along nicely, Putting the last assembly to make sure all is done and working and the 170 finishing up on the wiring and FWF…….I can almost see the light at the end of the tunnel
Daily routine
We are in the process of installing a Talian Leading edge and just completed a horizontal rebuild, it takes time…
DHC2
Repairing a Beaver horizontal stabilizer, opening up a can o worms