170 horizontal rebuild

 After removing the tail we found that an earlier replacement of the tail bulkheads with a later model 180 bulkhead, probably because of the plane going over on its back, was not done very well…….

Ground loop, not a bad one but still took some time

 Currently working on a ground loop repair to a Cessna 170B wing. If you watch you will see the three measurements for twist, the tool is made such that it should always be zero, the inboard, the middle, and the tip. You can see the twist is out by .7 which means it has only…

Floor viewing window for swing loadsThis was a fun job, but like most metal working jobs it always takes longer than they say. It also takes a bit of thinking as you do the installation about how it fits, it maybe different than the drawing, or holes may not be able to go where they…

 After removing the tail we found that an earlier replacement of the tail bulkheads with a later model 180 bulkhead, probably because of the plane going over on its back, was not done very well…….

Ground loop, not a bad one but still took some time

 Currently working on a ground loop repair to a Cessna 170B wing. If you watch you will see the three measurements for twist, the tool is made such that it should always be zero, the inboard, the middle, and the tip. You can see the twist is out by .7 which means it has only…

Floor viewing window for swing loadsThis was a fun job, but like most metal working jobs it always takes longer than they say. It also takes a bit of thinking as you do the installation about how it fits, it maybe different than the drawing, or holes may not be able to go where they…